Panasonic IP Phone KX T7050 User Manual

Home Automation Systems, Inc. (800) SMART-HOME  
(949) 221-9200 http://smarthome.com  
11. Unplug this product from the  
wall outlet and refer servicing  
E. If the product has been  
dropped or the cabinet has  
been damaged.  
F. If the product exhibits a  
distinct change in  
Important Safety Instructions  
to qualified  
personnel  
When using your telephone  
equipment, basic safety  
precautions should always be  
followed to reduce the risk of fire,  
electric shock and injury to  
persons, including the following:  
surface. This product should  
never be placed near or over  
a radiator or heat register.  
This product should not be  
placed in a built-in installation  
unless proper ventilation is  
provided.  
under the following conditions:  
A. When the power supply  
cord or plug is damaged  
or frayed.  
B. If liquid has been spilled  
into the product.  
C. If the product has been  
exposed to rain or water.  
D. If the product does not  
operate normally by  
performance.  
Avoid using a telephone  
12  
13  
(other than a cordless type)  
during an electrical storm  
There may be a remote risk of  
electric shock from lightning.  
1. Read and understand all  
instructions.  
7
Do not allow anything to rest  
on the telephone cord. Do not  
locate this product where the  
cord will be abused by  
2. Follow all warnings and  
instructions marked on the  
product.  
Do not use the telephone to  
report a gas leak in the  
vicinity of the leak.  
following the operating  
instructions. Adjust only  
those controls, that are  
covered by the operating  
instructions because  
improper adjustment of  
other controls may result in  
damage and will often  
require extensive work by  
a qualified technician lo  
restore the product to  
normal operation.  
persons walking on it.  
3. Unplug this product from the  
wall outlet before cleaning.  
Do not use liquid cleaners or  
aerosol cleaners. Use a damp  
cloth for cleaning.  
Do not overload wall outlets  
and extension cords as this  
can result in the risk of fire or  
electric shock.  
SAVE THESE  
INSTRUCTIONS  
9
Never push objects of any  
kind into this product through  
cabinet slots as they may  
touch dangerous voltage  
points or short out parts that  
could result in a risk of fire or  
electric shock. Never spill  
liquid of any kind on the  
product.  
Do not use this product near  
water, for example, near a  
bath tub, wash bowl, kitchen  
sink, or laundry tub, in a wet  
basement, or near a  
swimming pool.  
Do not place this product on  
an unstable cart, stand, or  
table. The product may fall,  
causing serious damage to  
the product.  
10 To reduce the risk of electric  
shock, do not disassemble  
this product, but take it to a  
qualified serviceman when  
some service or repair work is  
required. Opening or  
Slots and openings in the  
cabinet and the back or  
are provided for  
ventilation, to protect it from  
overheating, these openings  
must not be blocked or  
covered. The openings  
should never be blocked by  
placing the product on the  
bed. sofa, rug, or other  
removing covers may expose  
you to dangerous voltages or  
other risks. Incorrect  
reassembly can cause  
electric shock when the  
appliance is subsequently  
used.  
, _  
Home Automation SyDsotewnmlosad, Ifrnocm.W(w8w0.0So)mSaMnuAalRs.cTo-mH. OAllMMEanu(a9ls4S9e)a2rc2h1A-n9d2D0o0wnlhoatdtp. ://smarthome.com  
Thank you for purchasing the Panasonic Telephone.  
C onnec tion  
Connect as shown.  
Table of Contents  
Important safety instructions  
C o n n e c t i o n  
Initial setting  
W a l l  
m o u n t i n g  
To the EMSS control  
L o c a t i o n o f c o n t r o l s  
Accessory order information  
Important information  
Included accessories  
Handset  
one  
Telephone line cord one  
Handset  
cord  
- 3 -  
Home Automation SystDeomwnslo,aIdnfcro.m(W80w0w).SSomMaAnuRalTs.-cHomO.MAllEMa(n9u4al9s)S2ea2rc1h-9A2nd0D0owhntltopad:.//smarthome.com  
Initial setting  
Wall mounting  
This unit can be mounted on the wall phone plate  
Place the stand on the  
center of the unit.  
HANDSET VOLUME Selector:  
To adjust the volume level of the handset.  
NORMAL: Normal voice  
HIGH: Loud voice  
RINGER VOLUME Selector:  
To adjust the volume level of the ringer.  
HIGH: Loud ringer  
Remove the attached stand.  
Mount the unit on the wall  
phone plate.  
LOW: Low ringer  
OFF: No ringer  
VOLUME Control:  
To adjust the volume level of the speaker volume  
MAX: Loud voice  
MIN: Low voice  
Rotate the stand  
that the arrow on the stand  
shows UP for WALL  
turn so  
To temporarily place the handset  
down during a conversation, hook  
as shown.  
MEMORY Switch:  
Set to “SET’.  
For station programming, set to “PROGRAM”  
- 5 -  
- 6 -  
Home Automation Systems, Inc. (800) SMART-HOME (949) 221-9200 http://smarthome.com  
 
@PAUSE Button:  
INTERCOM Button and  
Indicator:  
Used for making or receiving  
an intercom call.  
Location of controls  
Inserts a pause between the  
access number and the  
phone number.  
@AUTO  
and Indicator:  
Button  
Button:  
the last number  
dialed.  
Used for dialing the system  
speed dialing/For storing  
functions into memory.  
@FLASH Button:  
Used for sending the hook  
flash signal to the CO line.  
Button:  
Used for speaking with three  
parties at the same time.  
Programmable Feature Buttons:  
Dials or accesses the system  
feature with one touch.  
MONITOR Button and  
Indicator:  
Used for making a call without  
using the handset.  
@Flexible CO Line Buttons and  
Indicators’:  
Used for dialing via CO line.  
Direct Station Selection, or  
Programmable Feature  
buttons.  
HOLD Button:  
Places a call on hold.  
@Flexible Message Waiting  
Button and Indicator:  
‘These functions are limited to the  
specified EMSS Control Units.  
Refer to the Installation manual.  
Used for Message  
Direct Station Selection, or  
Programmable Feature button,  
TRANSFER Button:  
Transfers a call to any  
extension.  
KX-T7050 is compatible with the Panasonic  
Switching Systems and can perform most  
s y s t e m .  
Modular  
each  
_
 
Home Automation Systems, Inc. (800) SMART-HOME (949) 221-9200 http://smarthome.com  
Accessory order information  
*Replacement parts and accessories are available through your local  
authorized parts distributor.  
(cont.)  
information  
Important  
NOTE:  
WARNING:  
equipment has been  
tested and found to comply  
with the limits for a Class  
digital device. pursuant to Part  
15 of the FCC Rules. These  
limits are designed to provide  
reasonable  
harmful Interference In a  
installation. This  
equipment generates. uses.  
and can radiate radio  
frequency energy and, if not  
installed and used in  
accordance with the  
may cause  
PREVENT  
OR  
HAZARD, DO NOT  
EXPOSE THIS PRODUCT TO  
RAIN OR ANY TYPE OF  
MOISTURE  
Part No.  
Picture  
Description  
Comment  
CAUTION:  
To assure continued  
7
against  
Handset cord  
compliance with FCC rules, do  
not make any unauthorized  
When  
programming emergency  
numbers and/or making test  
calls to emergency numbers:  
Remain on the line and  
briefly explain to the  
25  
KX-J25W.B  
harmful interference to radio  
dispatcher the reason for  
the call before hanging up.  
Perform such activities in  
the off-peak hours, such as  
early morning hours or late  
evenings.  
However,  
there is no guarantee that  
interference will not occur  
particular installation. If this  
Important information  
2
a
*Keep the unit away from heating  
appliances and electrical noise  
generating devices such as  
fluorescent lamps and motors.  
unit should be kept free of  
dust, moisture and vibration, and  
should not be exposed to direct  
sunlight.  
not use benzine, thinner, or  
the like, or any abrasive powder  
to clean the cabinet. Wipe it with  
a soft cloth.  
If there is any trouble, disconnect  
the unit from the extension line  
and connect a known working  
phone. If the known working  
phone operates properly, have it  
repaired by one of the specified  
Panasonic Factory Service  
Centers. If the known working  
phone does not operate properly,  
check the Electronic Modular  
Switching System and the internal  
wiring.  
equipment does cause harmful  
Interference to radio or  
television reception, which can  
be determined by turning the  
equipment off and on, the user  
is encouraged to try to correct  
the interference by one or  
more of the following  
This telephone provides  
magnetic coupling to  
a i d s  
INSTALLATION:  
1) Never install telephone  
wiring during a  
measures:  
-Reorient or relocate the  
antenna.  
-Increase the  
storm.  
2) Never install telephone jacks  
in wet locations unless the  
jack IS specifically  
not use any handset other  
than Panasonic handset.  
between  
receiver,  
and  
for wet  
-Connect the equipment into  
an outlet on a  
different from that to which  
the receiver is connected.  
-Consult the dealer or an  
experienced  
3) Never touch uninsulated  
telephone wires or terminals  
the telephone line  
has been disconnected at  
the network Interface.  
4) Use caution when installing  
or modifying telephone  
technician for  
help.  
 
Home Automation Systems, Inc. (800) SMART-HOME (949) 221-9200 http://smarthome.com  

Miele Vacuum Cleaner S 500 User Manual
NEC Computer Monitor EX231W User Manual
NEC Indoor Furnishings WMK3260 L User Manual
Nielsen Kellerman Watch 2000xc User Manual
NordicTrack Treadmill NTL12940 User Manual
Omega Vehicle Security Network Card iLD46 EI Series User Manual
Oregon Scientific Clock BAA339DPH User Manual
Panasonic Camcorder AJ D210P User Manual
Panasonic Cell Phone EB A200 User Manual
Panasonic Switch AVFS FS T User Manual